Features:
- Monitors up to three zones per premises or vehicle, plus manual paging
 - Connect to nearly any type of burglar alarm control panel, vehicle alarm, communications panel, etc.
 - One positive and two negative instant trigger inputs
 - Range: Up to one half mile (4W output)
 - Over two million possible coding combinations
 - Belt-clip receiver included
 - Code-learning receiver learns up to three transmitters
 - Color LEDs (Green, Orange, or Red) on the receiver indicate which zone of the premises or vehicle was triggered
 
Specifications
Transmitter
- # of codes - Over 2 million (factory pre-set)
 - Power - 12VDC
 - RF output power - 4W max.
 - Current drain
- Standby - 10mA
 - Active - 1A
 
 - Frequency - 27MHz
 - Antenna impedance - 50 Ω
 - Range - Up to 1/2 mile in open air1
 - Dimensions - 41/8x31/8x15/16 (105x79x33 mm)
 - Weight - 5.1-oz (145g)
 
Receiver
- # of codes - Learns up to 3 transmitter codes
 - Power - 3VDC (2 AAA batteries)2
 - Battery life - Approx. 1 month3
 - Current drain
- Standby - 1mAActive (Beep) - 20mA
 - Active (Vibrate) - 50mA
 
 - Dimensions - 3x21/8x5/8 (76x54x16 mm)Weight - 1.6-oz (45g) (without battery)
 
Software
- Trigger Indication - Colored LEDs and beeps
 - Transmitter Indication - PAGE LED flashes Red, Green or Orange
 - Positive Trigger Input
- LED Indicator - 'ZONE' LED flashes Green
 - Audible Indicator - Beeps in groups of 9 for 1 minute
 - Vibration Indicator - Vibrates in groups of 9 for 1 minute
 
 - Negative Trigger Input 1
- LED Indicator - 'ZONE' LED flashes Red
 - Audible Indicator - Beeps in groups of 9 for 1 minute
 - Vibration Indicator - Vibrates in groups of 9 for 1 minute
 
 - Negative Trigger Input 2
- LED Indicator - 'ZONE' LED flashes Orange
 - Audible Indicator - Beeps in groups of 9 for 1 minute
 - Vibration Indicator - Vibrates in groups of 9 for 1 minute
 
 - Manual Page
- LED Indicator - 'ZONE' LED flashes Green
 - Audible Indicator - Beeps in 3 groups of 3 for 1 minute
 - Vibration Indicator - Vibrates in 3 groups of 3 for 1 minute
 
 - Power ON
- LED Indicator - 'ZONE' LED will not be lit
 - Audible Indicator - Beeps in 3 groups of 3 for 1 minute
 - Vibration Indicator - Vibrates in 3 groups of 3 for 1 minute
 
 - Low Battery Indicator - Beep/vibrate twice every 60 seconds or when switch is pushed
 - Memory Indicator - Three continuous beeps/vibrates if no signals or at the end of all signals Beep/vibrate if the signal is an alarm page, will not beep/vibrate for manual page
 - Unattended Page Indicator - Beep/vibrate once every 30 seconds after initial signal is received. Will continue to beep until switch is pushed
 
            
 
								US Dollars